Make sure the build is less than 8 000 000 bytes before flashing it. Use the WRT610Nv2 mega file in the K26 or K3X folders. K3X did not yet exist in 14929, see below or research New Build and model-specific forum threads.These are 2.6 kernel builds and will work on v2 as well as v1: K3.X is similar but supports v2 only.įor example, these are 2.4 kernel builds, only for v1 routers ( THESE ARE NOT FOR INITIAL FLASH): To identify the difference, K2.4 builds aren't usually marked with any special identification, but K2.6 builds are in 'broadcom_K26' folder with 'K2.6' in the filename. You can install the K2.4 builds on v1, but not v2. DO NOT USE K3X on V1, NOR K24 on V2, OR YOU MAY BRICK YOUR ROUTER!įor (most) Broadcom MIPS routers, DD-WRT has three branches: broadcom using the 2.4 kernel, broadcom_K26 (2.6 kernel), and broadcom_K3X (3.10 kernel).Then upgrade to a newer good generic build (non-trailed build like mega.bin). Initial flash for v1 only: (14929) dd-wrt.v24_mega_wrt610n.bin.If installing DD-WRT for the first time on your WRT610N, you need to use a trailed (hardware-specific) build: NOTE: Eko builds have disappeared - use recommended build 14929 as a minimum.This is fixed in EKO build 12427, available here.DD-WRT will start, but immediately reboot, requiring debricking.16)īuilds between 1234 do not work on CFE. bootnv_ver=7, pmon_ver=CFE 4.175.64.16 (subsequently called CFE.bootnv_ver=6, pmon_ver=CFE 4.175.64.12 (subsequently called CFE.To find the CFE versions from within DD-WRT, run this from telnet/ssh, or use the Web GUI via 'Administration->Commands->Run nvram show|egrep 'bootnv|pmon' There are several variants of the WRT610N CFE. It's responsible for initial hardware configuration and subsequent booting of the (Linux OS) firmware. The CFE is the bootloader (like a PC BIOS/UEFI) for Broadcom devices. Dual-radio (two BCM4322) allows to operate 2.4 Ghz B/G/N and 5 Ghz A/N simultaneously.The WRT610N was a top-of-the-line consumer Linksys device (replaced by the E3000) with the following features: 7.8 PPPoE does not work with builds above 15506.7.4 Fixed Wireless MAC (FIXED SINCE 12360).7.3 Random reboots/WLAN lockups (FIXED since 13xxx).7.1 Unstable WLAN (especially when wl1 radio is enabled).

Dd wrt v24 usb ntfs